Polifilling 55, Cement Based Joint Filling

Description of Product
PoliFilling®55 is a cement based, joint filler grouting material decorative for ceramic, tile, marble and granite interlines. 

Fields of Application
-Indoor spaces, in vertical and horizontal applications, 
-In filling the grouting holes of ceramics, tiles, marble and granite adhered on existing surface.
-Shopping centers, 
-On commercial and industrial floors. In hotels, 
-In hospitals, 
-In wet spaces, 
-In domiciles

Features and Benefits
-Prepared and applied easily 
-Does not scratch silvered surfaces. 
-It is suitable for grouting holes with the widths 2 - 8 mm. 
-Provides excellent adhesion to the edges of tiles without cracking. 
-Has a long machinability duration. Smooth surfaces are obtained. 
-Since it has little water absorbance it hardly gets dirty and can be cleaned easily. 
-Freeze-thaw cycle resistant. 
-Resistant to impacts, vibrations and detergents. In the standard colors.

Application Procedure 
Preparation of Substrate
Before filling ceramics and tile grouting holes, it must be waited for the used adhesive to achieve sufficient hardness. Just before interlining materials are applied, the surface must be cleaned without being harmed and must be dampened with a wet sponge.

Mixing
Pour the amount of water indicated in the Mixing Ratios table into a clean mixing container with the assistance of a measuring cup. Add PoliFilling®55 slowly while mixing with a mixer that has a revolving frequency of 400 - 600 rev/min for about 3 - 5 minutes until a homogeneous mixture without pellets is obtained. Set it aside for about 3 - 5 minutes and the material becomes ready to use after it is mixed again for 30 more seconds. 

Mixting Ratios

Application Method
Spread PoliFilling®55 over the ceramics with a rubber trowel and fill the grouting interspaces. Skim the excessive material is off the grouting holes with diagonal moves. In deep grouting holes, first, wait for the settling of the material and repeat this procedure. Wait until the material can withstand the pressure of a finger and upon cleaning the whole surface with a wet sponge, give the life water that is necessary for the completion of the hydration. Clean the remaining materials on the surface of the ceramics with a wet sponge and give the final shape to the interlines. After the material gets dry (the day after by the latest), polish up the ceramic with a dry and clean oakum

Watch Points
-Avoid PoliFilling®55 application under excessive heat or wind and/or when the ambient and/or substrate temperature is below +10 or above +30. 
-Do not add water and/or new material to a PoliFilling®55  mixture which has started getting dry under any circumstances. Ceramics with high water absorbing capacity must be saturated with  water  before  the application. 

Coverage

Cleaning of Tools
Used tools and equipment must be cleaned with water after the application. 

Storage
Store in an unopened, original container, under dry and cool conditions and protect against frost. For short term storage, do not stack more than 3 palettes on top of each other and dispatch them on a first come - first go basis. Palettes should not be stacked on each other on a long term basis.

Shelf Life
12 months in original unopened packaging if stored in appropriate conditions. Opened packagings should be consumed in one week.
 

Cleaning of Tools
Used tools and equipment must be cleaned with water after the application. 

Storage
Store in an unopened, original container, under dry and cool conditions and protect against frost. For short term storage, do not stack more than 3 palettes on top of each other and dispatch them on a first come - first go basis. Palettes should not be stacked on each other on a long term basis.

Shelf Life
12 months in original unopened packaging if stored in appropriate conditions. Opened packagings should be consumed in one week.